Xerox WorkCentre 4150

January 2016
2-15
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
03-410 to 03-452, 03-500, 510, 520, 558, 559
Status Indicator RAPs
5. 03-420 to 03-442 Only. (4265) Refer to Wiring Diagram 13 and Wiring Diagram 40. (Per-
form the following:
a. Check the wiring between the paper size detect PWB, PL 7.20 Item 5 and CN5 on
the Tray PWB.
b. Check the wiring between CN1 on the relevant Tray PWB and CN34 on the Main
PWB.
c. Install new components as necessary:
• Paper size detect PWB, PL 7.20 Item 5.
• Paper size detect assembly, PL 7.20 Item 25.
• Tray connector, PL 7.20 Item 17.
d. Perform the OF5 Main PWB Check RAP.
03-500, 510, 520, 558, 559 Foreign Device Interface Fault
RAP
03-500 The machine has detected that there is no credit in the foreign device.
03-510 The machine has failed to detect the foreign device.
03-520 The foreign device interface is not active.
03-558 The foreign device interface is not active.
03-559 The foreign device interface is no longer active.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: The main PWB has test points. The location of the test points is shown on the following
PJ location illustrations:
• 4150 Main PWB.
• 4250/4260 Main PWB.
• 4265 Main PWB
Refer to:
• (4150) Wiring Diagram 8.
• (4250/4260) Wiring Diagram 26.
• (4265) Wiring Diagram 42
Perform the following:
1. If there is credit in the foreign device, check the wiring between the foreign device and the
foreign device interface PWB, (4150) PL 1.10 Item 15 or (4250/4260) PL 1.15 Item 15.
2. (4150) Check the wiring between CN2 on the foreign device interface PWB and CN28 on
the Main PWB. If necessary, install a new foreign device interface harness, PL 1.10 Item
27.
3. (4250/4260) Check the wiring between CN2 on the foreign device interface PWB and
CN24 on the Main PWB. If necessary, install a new foreign device interface harness, PL
1.10 Item 27.
4. (4265) Check the wiring between CN2 on the foreign device interface PWB and CN26 on
the Main PWB. If necessary, install a new foreign device interface harness, PL 1.10.
5. Install new components as necessary:
• Foreign device interface PWB (4150), PL 1.10 Item 15.
• Foreign device interface PWB (4250/4260/4265), PL 1.15 Item 15.
6. Perform the OF5 Main PWB Check RAP.