Xerox WorkCentre 4150

January 2016
2-16
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
03-600, 03-650
Status Indicator RAPs
03-600 Memory Failure RAP
03-600 The machine has detected a memory access failure.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Go to the relevant procedure:
• 4150 Checkout
• 4250/4260 Checkout
• 4265 Checkout
4150 Checkout
Refer to Wiring Diagram 5. Perform the following:
1. Switch off the machine, then switch on the machine.
2. Remove, then reinstall the memory DIMM, PL 1.10 Item 22.
3. If necessary, install a new memory DIMM, PL 1.10 Item 22.
4. Perform the OF5 Main PWB Check RAP.
4250/4260 Checkout
Refer to Wiring Diagram 27. Perform the following:
1. Switch off the machine, then switch on the machine.
2. Remove, then reinstall the memory DIMM, PL 1.15 Item 22.
3. If necessary, install a new memory DIMM, PL 1.15 Item 22.
4. Perform the OF5 Main PWB Check RAP.
4265 Checkout
Refer to Wiring Diagram 43. Perform the following:
1. Switch off the machine, then switch on the machine.
2. Remove, then reinstall the memory DIMM, PL 1.15 Item 22.
3. If necessary, install a new memory DIMM, PL 1.15 Item 22.
4. Perform the OF5 Main PWB Check RAP.
03-650 Ambient Temperature Sensor Fault RAP
03-650 The machine has detected a fault with the ambient temperature sensor.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: The main PWB has test points. The location of the test points is shown on the Main
PWB PJ location illustration.
Refer to (4250/4260/4265) Wiring Diagram 7, (4265) Wiring Diagram 42. Perform the following:
1. Switch off the machine, then switch on the machine.
2. (4250/4260) Check the wiring between the ambient temperature sensor, PL 1.10 Item 21
and CN26 on the Main PWB.
3. (4265) Check the wiring between the ambient temperature sensor, PL 1.10 Item 21 and
CN42 on the Main PWB.
4. If necessary, install a new ambient temperature sensor, PL 1.10 Item 21.
5. Perform the OF5 Main PWB Check RAP.