Xovis PC2 - Page 96

96 / 99 www.xovis.com
Prower Break Down
Internet connection OK
NTP-server set and reachable
Is this the first time you set-up
the sensor? Are you setting the
time manually now?
Yes
No
NTP time sync =>
time is valid
Quite valid time,
synchronization
recommended
Yes
No
Was the power break
only short, e.g. a
power cut only?
No
Invalid time,
synchronization
required
Yes
Sensor uses manually set time
Sensor uses last known time
before rebooting
and adds the
expected time of
the rebooting process => time is quite accurate
Sensor uses last known time before rebooting and adds the
expected time of
the rebooting process => due to long power
shutdown, time now is in the past