12. Electrical system
307
12.4.5 Inspection
(1) V belt inspection
1) Inspect the matter whether there are not
crack, stickiness and wear on the belt
visually.
Check that a belt doesn't touch the bottom
part of the pulley groove. If necessary,
replace the V belt set.
2) V belt tension:
(Refer to 2.2.2.(4) in Chapter 2.)
(2) Visual check of wiring and check of
unusual sound
1) Confirm whether wiring is right or there is no
looseness of the terminal part.
2) Confirm that there is no unusual sound from
the alternator during the engine operation.
(3) Inspection of charge lamp circuit
1) Move a start switch to the position of on.
Confirm lighting of the charge lamp.
2) Start an engine, and confirm the lights-out of
the lamp. Repair a charge lamp circuit when
a lamp doesn't work.
Normal
Clearance
Defect
011069-00E
To Next Page
Loading...
