52
3.3 Wiring the iC9200
1. Insert a suited screwdriver at an angel into the square opening as shown. Press and
hold the screwdriver in the opposite direction to open the contact spring.
2. Insert the stripped end of wire into the round opening. You can use wires with a cross
section of 0.08mm
2
up to 1.5mm
2
.
3. By removing the screwdriver, the wire is securely fixed via the spring contact to the
terminal.
(d) Standard Wiring
(1) DC 24V supply CPU:
DC 5V electronic section supply I/O area (max. 3A)
(2) Power module 007-1AB00:
DC 24V power section supply (max. 10A)
(3) DC 5V electronic section supply I/O area
(4) DC 24V power section supply I/O area
CAUTION
Since the power section supply is not internally protected, it is to be externally protected
with a fuse, which corresponds to the maximum current. This means max. 10A is to be pro-
tected by a 10A fuse (fast) respectively by a line circuit breaker 10A characteristics Z!
To Next Page
Loading...
