53
3.3 Wiring the iC9200
(e) Fusing
• The power section supply is to be externally protected with a fuse, which corresponds to the maximum current.
This means max. 10A is to be protected with a 10A fuse (fast) respectively by a line circuit breaker 10A char-
acteristics Z!
• It is recommended to externally protect the electronic power section supply for CPU an I/O area with a 2A
fuse (fast) respectively by a line circuit breaker 2A characteristics Z.
(f) State of the Electronic Power Supply via LEDs
After PowerON the RUN respectively MF LED at every System SLIO module is on, so far as the sum current
does not exceed the maximum value. With the CPU this is 3A. If the total current exceeds the maximum value,
the LEDs are no longer triggered. Here the power module with the order number 007-1AB10 is to be placed
between the periphery modules.
(2)
Wiring 8x Periphery Modules
(a) Terminal Module Terminals
With wiring the terminal modules, terminals with spring clamp technology are used for wiring. The spring clamp
technology allows quick and easy connection of your signal and supply lines. In contrast to screw terminal con-
nections this type of connection is vibration proof.
(b) Data
U
max
240VAC / 30V DC
I
max
10A
Cross section 0.08 ... 1.5mm
2
(AWG 28 ... 16)
Stripping length 10mm
(c) Wiring Proceeding
1 Pin no. at the connector
2 Opening for screwdriver
3 Connection hole for wire
CAUTION
Do not connect hazardous voltages!
If this is not explicitly stated in the corresponding module description, hazardous voltages
are not allowed to be connected to the corresponding terminal module!
Danger of injury from electrical shock and damage to the CPU respectively to the modules!
Put the iC9200 Series in a safe, powered down state before starting installation, disassembly
or wiring of the iC9200 Series modules!
3
Installation and Wiring
To Next Page
Loading...
