YASKAWA iC9200 Series

HB700 | CPU | PMC921xEx | en | 24-04 197
iC9200 Series
Web-based management - WBM
Security > SD Card
■ ‘Comment’
– Here you can comment your filter rule accordingly.
6.5.3 SD Card
Y
ou can use SD Card to enable the deployment of Yaskawa SD cards and retrieve
information about them.
WARNING
Data loss - card removal only when the power supply is switched off!
− Only remove the Yaskawa SD card when the power supply of the CPU is
switched of
f. Otherwise this will lead to data loss!
− If you remove the SD card during operation, the safety CPU switches to
the safe state (failure State).
General notes on using the Yaskawa SD card
− Only Yaskawa SD cards are supported.
− The cards are pre-formatted (ext4 format) for use in CPUs of the
iC9200 Series.
− When formatting again, certain information on the Yaskawa SD card
that is required for use in the CPUs of the iC9200 Series will be lost.
− Exclude the Yaskawa SD card from being formatted.
−
The Yaskawa SD card can be read at any time with a conventional
SD card reader. Sensitive data on the Yaskawa SD card can be read
if you do not physically protect it from unauthorized access.
− Make sure that unauthorized persons cannot access the Yaskawa SD
card.
SD Card
Security
TrustStores ...
Security
Certificate Authentication
F
irewall
SD Card
Syslog Configuration
User Authentication
Information
Diagnostics
Configuration
Administration
iC92...
PMC92...
■ Status
– The status of the currently used file system of the CPU is shown here.
■ Configuration
– Here you can enable (default setting) or disable the support of the Yaskawa SD
card by the CPU.
■ System Message
– Information on the current configuration and notes on potential security risks are
shown here.
■ [Apply] and [Discard]
– With the [Apply] button the selection is saved at Configuration and accepted after a
restart of the CPU.
– You can discard your selection with the [Discard] button.