Administrator’s Guide for SIP-T3xG IP Phones
10
2. Connect the supplied Ethernet cable between the Internet port on the IP phone and
the Internet port in your network or switch/hub device port.
Power over Ethernet
Using a regular Ethernet cable, the IP phones can be powered from a PoE (IEEE 802.3af)
compliant switch or hub.
To connect the PoE:
1. Connect the Ethernet cable between the Internet port on the IP phone and an
available port on the in-line power switch/hub.
Note
If in-line power is provided, you do not need to connect the AC adapter. Make sure the
Ethernet cable and switch/hub is PoE compliant.
The IP phone can also share the network with other network device such as a PC
(personal computer). It is an optional connection.
Important! Do not unplug or remove power while the IP phone is updating firmware and
configurations.
To Next Page
Loading...
