How to fix Err. 2 (Sample Temperature Error) on YOKOGAWA FC400G?
To fix Err. 2 (Sample Temperature Error), control the sample temperature to be in the range of 0.0 to 50.0°C. If the error persists within this range, the RTD may be defective (open circuited), and the counter electrode should be replaced.
Why does the reading deviate significantly or overshoot on YOKOGAWA FC400G?
Significant deviation or overshoot in readings can occur if span calibration was not performed correctly, particularly if electrode sensitivity initialization was set to ON (1) in service code 08 (“CHANG” Mode) and a calibration solution with a large concentration difference was used. Set electrode sensitivity initialization to ON (1) in service code 08 (“CHANG” Mode) and perform calibration again.
What causes Err. 5 (Slope Error) on YOKOGAWA FC400G and how to fix it?
Err. 5 (Slope Error) can be caused by aged calibration standard solution, incorrect concentration value, or a deteriorated indicator electrode. Confirm if any of these are present. If the error persists after recalibration with a new solution or polishing the electrode with alumina, the indicator electrode should be replaced.
What to do if the measured value does not vary on YOKOGAWA FC400G?
If the measured value does not vary, consider these possibilities: * The measuring tank may have no sample water. Repair any abnormalities such as piping disconnection or sample water feed failure to restore normal conditions. * The electrode to electrode circuit may be open. Repair the open circuit, or replace the electrode if the open circuit occurs in it. * No voltage may be applied between the indicator and counter electrodes. Check the converter.
Why does the measured value fluctuate largely on YOKOGAWA FC400G?
Large fluctuations in measured values can occur if: * The indicator electrode does not rotate at a constant speed. Check if the set screws have loosened and if the belt and driven shaft assembly are normal. If not, replace them. * There is insufficient continuity at the electrode mechanism block. Replace the rotating contact.
What to do if the measured value is abnormal in YOKOGAWA FC400G?
If the measured value is abnormal, it might be due to several reasons: * The indicator electrode may have stopped because the electrode drive belt doesn't turn. If the electrode drive belt does not turn, sufficiently tighten the set screw. The cell motor may not run. If the cell motor does not run, replace the motor with a new one. * The indicator electrode may have worn out; replace it with a new one. * There may be insufficient continuity at the electrode mechanism block; replace the rotating contact.
How to fix large measurement error on YOKOGAWA FC400G?
To address large measurement errors, try the following: * Polish the indicator electrode. * Clean the ceramic beads (or replace them if cleaning is insufficient). * Conduct zero and/or span calibration. * Replace the activated charcoal filter if auto zero calibration is abnormal or the piping related to auto zero calibration is blocked.
General| Type | Flow Meter |
|---|---|
| Input Channels | 1 |
| Display | LCD |
| Power Supply | 24 V DC |
| Number of I/O Slots | 2 |
| Output Signal | 4-20 mA |
| Material | Stainless Steel |
| Communication Protocols | HART, MODBUS |
| Operating Temperature | -40 to 85 °C |
| Process Connection | Flange |
To Next Page
