EasyManuals Logo

YOKOGAWA ScopeCorder DL850E User Manual

YOKOGAWA ScopeCorder DL850E
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #178 background imageLoading...
Page #178 background image
14-1
IM DL850E-01EN
14 Action
If Mode is set to ON, the specified action (operation) is performed in the following situations. However, if the
trigger mode is set to N Single, the DL850E/DL850EV cannot start waveform acquisition when Mode has been
set to ON.
When the DL850E/DL850EV triggers, and the corresponding waveform acquisition stops
When the action condition of GO/NO-GO determination is met
When waveform acquisition stops
Mode (Mode)
Select whether to use the actions.
OFF: The actions are not used.
ON: The actions are executed.
Action (Action Setup)
You can select the actions from the options below.
Beep (Beep)
The DL850E/DL850EV sounds an alarm.
Screen Capture Printing (Print Image)
The DL850E/DL850EV prints a screen capture to the specified printer. You can specify a printer in the PRINT
menu by setting “Print to” to BuiltIn (built-in printer) or Network (network printer).
Waveform Data Saving (Save Waveform)
The DL850E/DL850EV saves the waveform data to the specified destination (SD card, internal or external HD
[option], USB storage device, or network drive).
File Path (File Path)
Specify where to save the file.
Auto Naming (Auto Naming), File Name (File Name), Data Format (Data Type)
These settings are the same as the auto-naming, file-name, and data-format settings for saving waveform
data.
Changing the auto-naming, file-name, and data-format settings for saving waveform data will change the
auto-naming, file-name, and data-format settings under Waveform(SAVE) in the FILE menu.
Screen Capture Saving (Save Image)
The DL850E/DL850EV saves the screen capture data to the specified destination (SD card, internal or external
HD [option], USB storage device, or network drive).
File Path (File Path), Auto Naming (Auto Naming), File Name (File Name)
Changing the auto-naming and file-name settings for saving image data will change the auto-naming and file-
name settings under Others(SAVE) in the FILE menu.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YOKOGAWA ScopeCorder DL850E and is the answer not in the manual?

YOKOGAWA ScopeCorder DL850E Specifications

General IconGeneral
BrandYOKOGAWA
ModelScopeCorder DL850E
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals