YUNEEC H520 - ST16 S Ground Station; Powering on the ST16 S Controller

Yuneec Electric Aviation
H520 Start Guide
7
ST16S GROUND STATION: Charge the ST16S battery by using supplied USB cable and inserting it into
the USB port on the charger. It will take approximately five hours to charge a fully discharged battery.
POWERING ON THE ST16S CONTROLLER
Power on the ST16S Controller by sliding the switch at the bottom of the ST16S to the left. A blue light will
illuminate next to the switch and a “YUNEEC” splash screen will appear. DataPilot™ will automatically
start, and the DataPilot™ Home screen will display.
WARNING
Do not leave the battery in the charger after the battery is fully charged.