DataWedge
60
• On connect/disconnect - Selects an external scanner as the default scanning device immediately upon
connection. Upon disconnection, reverts to the scanner set as the default prior to the external connection.
NOTE: The system selects the default scanner based on the connection state and the scanner's position in an internally
managed scanner list. If the newly connected scanner is lower in the scanner list than the one currently selected as the de-
fault scanner, the newly connected scanner becomes the default scanner.
On devices with only one built-in scanner or imager, On disconnect reverts to that built-in scanner or imager.
Decoders
Configures which barcode decoders are enabled or disabled. For best performance disable all unnecessary
decoders.
Touch Decoders. The Barcode input screen appears. A check in the checkbox indicates that the decoder is
enabled. By default the most commonly used decoders are enabled (shown below with an asterisk). The
supported decoders are:
NOTE: DataWedge supports the decoders listed below but not all are validated on this device.
Table 5 Supported Decoders
Decoders
Camera
Internal Imager
SE2100
Internal Imager
SE4710
RS507/RS507X
RS6000
DS2278
DS3678
LI3678
Australian
Postal
O O O O O O O --
Aztec X X X X X X X --
Canadian
Postal
O O O -- O -- -- --
Chinese 2 of 5 O O O O O O O O
Codabar X X X X X X X X
Code 11 O O O O O O O O
Code 128 X X X X X X X X
Code 39 X X X X X X X X
Code 93 O O O O O O O O
Composite AB O O O O O O O --
Composite C O O O O O O O --
Discrete 2 of 5 O O O O O O O O
Datamatrix X X X X X X X --
Dutch Postal O O O O O O O --
To Next Page
Loading...
Need help?
General
