15
Getting Started
Introduction
This chapter provides information for getting the device up and running for the first time.
Setup
Perform this procedure to start using the TC20 for the first time.
1. Install a micro secure digital (SD) card (optional).
2. Charge the TC20.
3. Power on the TC20.
Installing a microSD Card
The microSD card slot provides secondary non-volatile storage. The slot is located under the access door.
Refer to the documentation provided with the card for more information, and follow the manufacturer’s
recommendations for use.
caution:
Follow proper electrostatic discharge (ESD) precautions to avoid damaging the microSD card. Proper ESD pre-
cautions include, but are not limited to, working on an ESD mat and ensuring that the operator is properly grounded.
1. Using a Phillips #0 screwdriver, remove two screws securing the access door.
Figure 2 Remove Access Door
To Next Page
Loading...
Need help?
General
