Troubleshooting
Print Engine Diagnostics
136
P1051584-002 8/23/12
FEED + PAUSE Self Test
Performing this self test temporarily resets the print engine configuration to the factory default
values. These values are active only until power is turned off unless you save them
permanently in memory. If the factory default values are permanently saved, a sensor
calibration procedure must be performed. (See
Calibrate the Ribbon and Media Sensors
on page 99.)
To perform a FEED and PAUSE self test, complete these steps:
1. Turn off (O) the print engine.
2. Press and hold FEED + PAUSE while turning on (I) the print engine.
3. Hold FEED + PAUSE until the first control panel light turns off.
The print engine configuration is reset to the factory default values. No labels print at the
end of this test.
CANCEL + PAUSE Self Test
Performing this self test temporarily resets the network configuration to the factory default
values. These values are active only until power is turned off unless you save them
permanently in memory.
To perform a CANCEL and PAUSE self test, complete these steps:
1. Turn off (O) the print engine.
2. Press and hold CANCEL + PAUSE while turning on (I) the print engine.
3. Hold CANCEL + PAUSE until the first control panel light turns off.
The printer’s network configuration is reset to the factory default values. No labels print at
the end of this test.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
