Printer Setup and Operation
Select a Data Communication Interface
58
P1051584-002 8/23/12
Data Cables
You must supply all data cables for your application.
Ethernet cables do not require shielding, but all other data cables must be fully shielded and
fitted with metal or metallized connector shells. Unshielded data cables may increase radiated
emissions above the regulated limits.
To minimize electrical noise pickup in the cable:
• Keep data cables as short as possible.
• Do not bundle the data cables tightly with the power cords.
• Do not tie the data cables to power wire conduits.
Wireless print server Option Limitations and Requirements
• Can print to the print engine from any computer on your
Wireless Local Area Network (WLAN).
• Can communicate with the printer through the print engine’s
web pages.
• The print engine must be configured to use your WLAN.
• A parallel connection or a wired print server (if installed) takes
up this port on the print engine.
Configuration Refer to the ZebraNet Wired and Wireless Print
Servers User Guide for configuration instructions. A copy of this
manual is available at
http://www.zebra.com/manuals or on the
user CD that came with your print engine.
Table 4 • Data Communication Interfaces (Continued)
Interface
Standard or
Option
Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
