Introduction
Control Panel Display
20
P1051584-002 8/23/12
Changing Password-Protected Parameters
Certain parameters, including the communication parameters, are password-protected by
factory default.
The first time that you attempt to change a password-protected parameter, the print engine
displays
ENTER PASSWORD. Before you can change the parameter, you must enter the
four-digit numeric password. After you have entered the password correctly, you do not have
to enter it again unless you leave Setup mode by pressing SETUP/EXIT or by turning off (
O)
the print engine.
To enter a password for a password-protected parameter, complete
these
steps:
1. At the password prompt, use MINUS (-) to change the selected digit position.
2. When you have selected the digit that you wish to change, use PLUS (+) to increase the
selected digit value. Repeat these two steps for each digit of the password.
3. After entering the password, press SELECT.
The parameter you selected to change is displayed. If the password was entered correctly,
you can change the value.
Default Password Value
The default password value is 1234. The password can be changed using the Zebra
Programming Language (ZPL) command
^KP (Define Password) or using the print engine’s
web pages (ZebraNet wired or wireless print server required).
Disable the Password Protection Feature
You can disable the password protection feature so that it no longer prompts you for a
password by setting the password to 0000 via the
^KP ZPL command. To re-enable the
password-protection feature, send the ZPL command
^KPx, where x can be any number from
1 to 9999.
Caution • Do not change password-protected parameters unless you have a complete
understanding of the parameters’ functions. If the parameters are set incorrectly, the print
engine may function unpredictably.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
