Version 8.0
G-30-1682-en Page 13
S88 / OPMI Lumera T Safety measures
Requirements for operation
Prior to the very first use
A ZEISS Service representative or an expert authorized by ZEISS will install the
system. Please make sure that the following requirements continue to be met
for further operation:
9 The connecting components have been properly connected. The screw
connections have been firmly tightened.
9 All cables and plugs are in perfect condition, i.e. without signs of wear,
kinks or other damage.
9 The voltage set on the system corresponds to the rated line voltage on the
site of installation.
9 The device is connected with the power cord supplied.
9 When connecting the device to a network, please make sure that the
network does not carry any hazardous voltage.
• Never place multiple connectors on the floor.
• Do not connect any additional multiple electrical outlets.
• Only connect compatible components to the system.
• Do not exceed the max permissible electrical load of multiple electrical
outlets.
• Use multiple electrical outlets only for components of the system.
WARNING The device must not be modified without any approval!
Do not modify the device without approval from the manufacturer.
If the device is modified, suitable inspections and testing must be carried out
to ensure that it can still be used safely.
The manufacturer is not liable for damages caused by an unauthorized use
of the device. Furthermore, such unauthorized modifications will render the
warranty and any claims under warranty invalid.
WARNING Danger! Electrical voltage!
• To avoid the risk of electrical shock, this device may only be connected to
a power supply network which is provided with a protective ground
conductor.
To Next Page