ZKTeco ProCapture-T User Manual

2 ProCapture-T & PRoRF-T User Manual
1.2 Verification Modes
1.2.1 1:N Fingerprint Verification
Under the fingerprint verification method, a fingerprint collected by the sensor is verified with all
fingerprints stored in the device.
Please use the correct way to press fingerprint onto the fingerprint sensor (for detailed instruction, please
refer to 1.1 Method of Pressing Fingerprint).
Verification Succeeds Verification Succeeds Verification Fails
Remarks：
1. In the devices possessing Photo ID function and enabling [Display User Photo] at the same time,
figure 1 will be displayed on screen after successful verification. Disable the [Display User Photo]
option, figure 2 will be displayed after successful verification.
2. In the initial interface, press
> System > Access Logs Setting > Display User Photo, and press
to enable or disable the [Display User Photo] option.
Only some products are equipped with Photo ID function. Products without Photo ID function will not
display user photo after successful verification.
1.2.2 1:1 Fingerprint Verification
Under the fingerprint verification method, a fingerprint collected by the sensor is verified with the
fingerprint corresponding to the entered user ID. Please use this method when difficulty is encountered
in 1:N fingerprint verification.

ZKTeco ProCapture-T Specifications

General

Type	Intelligent access control reader
Product color	Black
Cards capacity	10000 cards
RFID frequency	0.125 MHz
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Password
PC connection	RS-485/Wiegand
Supported network protocols	TCP/IP
Viewing angle, horizontal	120 °
Display type	TFT-LCD
Display diagonal	2.4 \
Operating temperature (T-T)	-10 - 50 °C
DC voltage range	12 - 12 V
Power consumption	500 mA
Flash memory	0.256 GB
Internal memory	0.128 GB
Processor frequency	1200 MHz

Weight and Dimensions

Depth	35 mm
Width	87 mm
Height	195.5 mm