Error! Use the Home tab to apply 标题 1 to the text that you want to appear here.
49
16 Appendices
16.1 Photo ID Function
Remarks: Some models support Photo ID function.
When the Photo ID function is enabled, and the user passes
verification, not only the information of user ID and name will be
displayed, but also the photo registered by the user or saved in
the USB disk will be shown.
Remarks：
Enabling [Display User Photo] (in the initial interface, press
> System > Access Logs Setting >
Display User Photo, and press
to enable the [Display User Photo] option) at the same time is needed
to display user photo after successful verification. If [Display User Photo] is disabled, user photo will not
be displayed after successful verification even if the device possessing Photo ID function.
[Operating Procedure]
If the user photo taken by the device is used, the photo will be displayed right after user verification.
If the user photo in a USB disk is used, the operating procedure is as below:
(1) Create a file named as “photo” in the USB disk, and save the user photo in the file.
(2) The photo format must be JPG, and the file must be named as the user ID. For example: the photo
corresponding to the user with the ID of 154 should be named as 154.jpg.
(3) Insert the USB disk into the USB port of the device, and enter USB Manager > Upload > User Portrait
to upload users’ photos. The photo will then be shown after user verification.
Note:
(1) The photo name must be within 9 digits.
(2) The photo size should be less than 15k.
(3) The newly uploaded photo will replace the original photo of the user.
(4) When downloading user photo, enter USB Manager > Download > User Portrait, a file named as
“photo” will be created in the USB disk automatically, in which all downloaded user photos will be saved.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
