Error! Use the Home tab to apply 标题 1 to the text that you want to appear here.
35
and trigger Door open and Alarm.
Verify Mode by RS485
: To turn on RS485 reader function; it is the verification method used by the
device when it is the master/slave device.
Speaker Alarm: When the [Speaker Alarm] is enabled, the speaker will raise an alarm when the device
is being dismantled.
Reset Access Setting: To reset parameters of door lock delay, door sensor delay, door sensor type,
verification mode, door available time period, NO time period, auxiliary input configuration, speaker alarm,
anti-passback direction,. However, the content of the Access Data deletion in [Data Mgt.] will not be
affected.
Access Parameters Factory Default
Door Lock Delay 5 s
Door Sensor Delay 10 s
Door Sensor Type Normal Open (NO)
Verification Mode Password/Fingerprint/Badge
Door Available Time Period 1
NO Time Period None
Aux output/Lock open time 255 s
Aux output type setting Trigger door open
Speaker Alarm Off
Anti-Passback Direction No anti-passback
10.2 Time Rule Settings
Time Rule is the minimum time unit of access control settings; at most 50 Time Rules can be set for the
system. Each Time Rule consists of 7 time schedules (a week) and 3 holiday time schedules, and each
time schedule is the valid time within 24 hrs.
You may set a maximum of 3 time periods for every time schedule. The relationship among these time
periods is "or". When the verification time falls in any one of these time periods, the verification is valid.
The time period format is HH:MM-HH:MM in the 24-hour system with precision to minute.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
