ZKTeco ProCapture-T User Manual

16 ProCapture-T & PRoRF-T User Manual
 Device ID Settings
If the communication method is RS232/RS485, inputting this device ID in the software communication
interface is required.
In the initial interface, press
> Comm. > PC Connection > Device ID to enter the Device ID setting
interface.
Device ID: Identity number of the device, which ranges between 1~254.
6.4 ADMS
Settings used for connecting with ADMS server, such as IP address and port settings, and whether to
enable proxy server etc.
In the initial interface, press
> Comm. > ADMS to enter the ADMS server setting interface.
When the Webserver is connected successfully, the main interface will display the
logo.
Server Address: Enter IP address of the ADMS server (namely, the IP address of server where the
software is installed).
Server Port: Enter Port number used by the ADMS server.
Enable Proxy Server: Method of enabling proxy. To enable proxy, please set the IP address and port
number of the proxy server. Entering proxy IP and server address will be the same.

ZKTeco ProCapture-T Specifications

General

Type	Intelligent access control reader
Product color	Black
Cards capacity	10000 cards
RFID frequency	0.125 MHz
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Password
PC connection	RS-485/Wiegand
Supported network protocols	TCP/IP
Viewing angle, horizontal	120 °
Display type	TFT-LCD
Display diagonal	2.4 \
Operating temperature (T-T)	-10 - 50 °C
DC voltage range	12 - 12 V
Power consumption	500 mA
Flash memory	0.256 GB
Internal memory	0.128 GB
Processor frequency	1200 MHz

Weight and Dimensions

Depth	35 mm
Width	87 mm
Height	195.5 mm