ZKTeco ProCapture-T User Manual

Error! Use the Home tab to apply 标题 1 to the text that you want to appear here.
21
In the initial interface, press
> Comm. > Wiegand Setup > Card format detect automatically to
enter the Card format detect automatically interface.
Operating Procedure:
1. After entering the [Card Format Detect Automatically] interface of an ID device, swipe the ID card
above the card reader (on the local device or auxiliary card reader), the interface will show the
automatically detected Wiegand formats and the analyzed card numbers.
2. Choose the item corresponding to the actual card number as the device’s [Wiegand format],
which is the Wiegand format for reading that type of card.
 Remarks: In the [Card format detect automatically] interface of an IC device, the device cannot
detect the card number or Wiegand format only by swiping an IC card. For detecting the Wiegand format
of an IC card, it is needed to connect an IC card reader with the device and swipe an IC card above the
auxiliary card reader, so that the device will show the card number and the Wiegand format.

ZKTeco ProCapture-T Specifications

General

Type	Intelligent access control reader
Product color	Black
Cards capacity	10000 cards
RFID frequency	0.125 MHz
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Password
PC connection	RS-485/Wiegand
Supported network protocols	TCP/IP
Viewing angle, horizontal	120 °
Display type	TFT-LCD
Display diagonal	2.4 \
Operating temperature (T-T)	-10 - 50 °C
DC voltage range	12 - 12 V
Power consumption	500 mA
Flash memory	0.256 GB
Internal memory	0.128 GB
Processor frequency	1200 MHz

Weight and Dimensions

Depth	35 mm
Width	87 mm
Height	195.5 mm