SpeedFace-V5L Series User Manual
Page | 30 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Procedure to Set for Combined Verification Mode
Combined verification requires personnel to register all the different verification methods. Otherwise,
employees may not be able to successfully verify through the combined verification process.
For instance, when an employee has registered only the face data, but the Device verification mode is
set as "Face + Password", the employee will not be able to complete the verification process
successfully.
This is because the Device compares the scanned face template of the person with registered
verification template (both the Face and the Password) previously stored to that Personnel ID in the
Device.
But as the employee has registered only the Face but not the Password, the verification will not get
completed and the Device displays "Verification Failed".
Note:
"/" means "or", and "+" means "and".
You must register the required verification information before using the combination verification
mode, otherwise the verification may fail. For example, if a user uses Face Registration but the
verification mode is Face + Password, this user will never pass verification.
To Next Page
Loading...
