ZKTeco SpeedFace-V5L Series - Access Logs Setting

To Next Page

To Previous Page

SpeedFace-V5L Series User Manual

If users need to set date and time manually, disable Date and Time Auto Sync first, and then tap Manual

Time Setting to set date and time and tap Confirm to save.

Tap Select Time Zone to select a time zone then tap the return button to save and exit.

Tap 24-Hour Time to enable or disable this format. If enabled, then select the Date Format to set the date

format i.e., the way date should be displayed on the device.

Tap Daylight Saving Time to enable or disable the function. If enabled, tap Daylight Saving Mode to

select a daylight-saving mode and then tap Daylight Saving Setup to set the switch time.

Week Mode Date Mode

When restoring the factory settings, the time (24-hour) and date format (YYYY-MM-DD) can be restored,

but the device date and time cannot be restored.

Note: For example, if a user sets the time of the device (18:35 on March 15, 2019) to 18:30 on January 1,

2020. After restoring the factory settings, the time of the device will remain at 18:30 on January 1, 2020.

Other manuals for ZKTeco SpeedFace-V5L Series