Zoom F6 - Setting the Attack Time; Setting the Threshold

118
■ Setting the threshold
This sets the base level from which the limiter operates.
5. Use and to select
Threshold, and press
.
6. Use and to adjust
the setting, and press
.
HINT
This can be set from −16 to −2 dBFS.
■ Setting the attack time
This sets the amount of time until compression starts after the input
signal exceeds the threshold.
5. Use and to select
Attack Time, and press
.
6. Use and to adjust
the time, and press
.
HINT
This can be set from 1 to 4 ms.