Zoom F6 - Setting the User Bits for Internal Timecode

128
5. Use and to select
On, and press
.
NOTE
This cannot be set when Mode is set to Off, Int Free Run, Int Rec Run or Int
RTC Run.
■ Setting the user bits for internal timecode
User bits are data that can be set for inclusion in the timecode. Up to 8
numbers (0–9) and letters (A–F) can be included. Recording date infor-
mation, for example, can be useful when editing later.
Setting the user bits (Ubits) mode
3. Use and to select
Ubits, and press
.
4. Use and to select
Mode, and press
.