Zoom F6 - Linking the Limiter; Setting the Release Time

119
■ Setting the release time
This sets the amount of time until compression stops after the input
signal goes below the threshold.
5. Use and to select
Release Time, and press
.
6. Use and to adjust
the time, and press
.
HINT
This can be set from 1 to 500 ms.
■ Linking the limiter
The line output limiters can be linked or applied independently.
5. Use and to select
Link, and press
.
6. Use and to select
Off, and press
.
Setting Explanation
Off Separate limiter operation.
On
Link limiter operation. If the signal for either linked signal reaches
the threshold, the limiter will operate on both channels.