Chapter 8 Wireless LAN
AMG1302-T10A User’s Guide
106
8.2.6 MAC Filter
Use this screen to change your Device’s MAC filter settings. Click the Edit button in the AP screen.
The screen appears as shown.
Figure 52 Network > Wireless LAN > AP: MAC Address Filter
The following table describes the labels in this screen.
8.3 The More AP Screen
This screen allows you to enable and configure multiple Basic Service Sets (BSSs) on the Device.
Table 34 Network > Wireless LAN > AP: MAC Address Filter
LABEL DESCRIPTION
Enable MAC
Filter
Select the check box to enable MAC address filtering.
Filter Action
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Deny to block access to the Device. MAC addresses not listed will be allowed to access
the Device
Select Allow to permit access to the Device. MAC addresses not listed will be denied access
to the Device.
Set
This is the index number of the MAC address.
MAC Address Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.
To Next Page
Loading...
