ZyXEL Communications AMG1302-T10A - 11.4 The IP;MAC Filter Screen

Chapter 11 Filters
AMG1302-T10A User’s Guide
156
11.4 The IP/MAC Filter Screen
Use this screen to create and apply IP/MAC filters. Click Security > Filter > IP/MAC Filter. The
screen appears as shown.
Figure 87
Security > Filter > IP/MAC Filter
The following table describes the labels in this screen.
Table 58 Access Management > Filter (IP/MAC)
LABEL DESCRIPTION
IP/MAC Filter Rule Editing
IP/MAC Filter Set Index Select the index number of the filter rule.
Active Use this field to enable or disable the rule.
Interface Select the PVC to which to apply the filter.
Direction Apply the filter to Both, Incoming or Outgoing traffic direction.
Rule Type Select IP or MAC type to configure the rule.
Use the IP Filter to block traffic by IP addresses.
Use the MAC Filter to block traffic by MAC address.
Source IP Address Enter the source IP address of the packets you wish to filter. This field is
ignored if it is 0.0.0.0.
Subnet Mask Enter the IP subnet mask for the source IP address
Port Number Enter the source port of the packets that you wish to filter. The range of this
field is 0 to 65535. This field is ignored if it is 0.
Destination IP Address Enter the destination IP address of the packets you wish to filter. This field is
ignored if it is 0.0.0.0.