ZyXEL Communications AMG1302-T10A - The Port Forwarding Rule Edit Screen

Chapter 9 Network Address Translation (NAT)
AMG1302-T10A User’s Guide
132
9.3.2 The Port Forwarding Rule Edit Screen
Use this screen to edit a port forwarding rule. Click the rule’s edit icon in the Port Forwarding
screen to display the screen shown next.
Figure 70 Network > NAT > Port Forwarding: Edit
The following table describes the fields in this screen.
Table 45 Network > NAT > Port Forwarding: Edit
LABEL DESCRIPTION
Rule Setup
Active Click this check box to enable the rule.
Service Name Enter a name to identify this port-forwarding rule.
Start Port Enter a port number in this field.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port field.
End Port Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port field above and
then enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with the
port number in the Start Port field above.
Server IP
Address
Enter the inside IP address of the server here.
Port Translation
Start / End Port
Enter the start port number here to which you want the device to translate the incoming
port. For a range of ports, you only need to enter the first number of the range to which
you want the incoming ports translated, the device automatically calculates the last port of
the translated port range.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.