Chapter 19 CWMP
AMG1302-T10A User’s Guide
200
19.2 The CWMP Setup Screen
Use this screen to configure your Device to be managed by a management server. Click
Advanced> CWMP to display the following screen.
Figure 110 Advanced > CWMP
The following table describes the fields in this screen.
Table 76 Advanced > CWMP
LINK DESCRIPTION
CWMP Setup
CWMP Select Activated to allow the Device to be managed by a management server or select
Deactivated to not allow the Device to be managed by a management server.
ACS Login
Information
Configure this part of the screen to log into the management server.
URL Type the IP address or domain name of the management server. If the Device is behind a
NAT router that assigns it a private IP address, you will have to configure a NAT port
forwarding rule on the NAT router.
User Name The user name is used to authenticate the Device when making a connection to the
management server. This user name on the management server and the Device must be
the same. Type a user name of up to 255 printable characters found on an English-language
keyboard. Spaces and characters such as @#$%^&*()_+ are allowed.
To Next Page
Loading...
