Chapter 8 Wireless LAN
AMG1302-T10A User’s Guide
108
The following table describes the fields in this screen.
8.4 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS.
Table 36 Network > Wireless LAN > More AP: Edit
LABEL DESCRIPTION
Network Name (SSID) The SSID (Service Set IDentity) identifies the service set with which a wireless
device is associated. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Note: If you are configuring the Device from a computer connected to the wireless
LAN and you change the Device’s SSID or security settings, you will lose your
wireless connection when you press Apply to confirm. You must then change
the wireless settings of your computer to match the Device’s new settings.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Security Mode See Section 8.2 on page 99 for more details about this field.
MAC Filter This shows whether the wireless devices with the MAC addresses listed are allowed
or denied to access the Device using this SSID.
Edit Click this to go to the MAC Filter screen to configure MAC filter settings. See
Section 8.2.6 on page 106 for more details.
QoS Select this check box to activate Quality of Service (QoS).
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.
To Next Page
Loading...
