ZyXEL Communications AMG1302-T10A - Configuring Static Route for Routing to Another Network

Chapter 4 Tutorials
AMG1302-T10A User’s Guide
40
3 Select Enable MAC Filter and Deny Association. Enter the MAC address you found in the Client
List screen. Click Apply.
Josephine will no longer be able to access the Internet through the Device.
4.4 Configuring Static Route for Routing to Another
Network
In order to extend your Intranet and control traffic flowing directions, you may connect a router to
the Device’s LAN. The router may be used to separate two department networks. This tutorial
shows how to configure a static routing rule for two network routings.
In the following figure, router R is connected to the Device’s LAN. R connects to two networks, N1
(192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from computer A (in N1
network) to computer B (in N2 network), the traffic is sent to the Device’s WAN default gateway by
default. In this case, B will never receive the traffic.
N2
B
N1
A
R