Chapter 17 Remote Management
AMG1302-T10A User’s Guide
182
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Figure 102 Advanced > Remote MGMT > Telnet
The following table describes the labels in this screen.
17.4 The FTP Screen
You can use FTP (File Transfer Protocol) to upload and download the Device’s firmware and
configuration files. Please see the User’s Guide chapter on firmware and configuration file
maintenance for details. To use this feature, your computer must have an FTP client.
Use this screen to specify which interfaces allow FTP access and from which IP address the access
can come. To change your Device’s FTP settings, click Advanced > Remote MGMT > FTP. The
screen appears as shown.
Figure 103 Advanced > Remote MGMT > FTP
Table 70 Advanced > Remote Management > Telnet
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must use
the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the Device using this
service.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the Device
using this service.
Select All to allow any computer to access the Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the Device using this service.
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.
To Next Page
Loading...
