Chapter 10 Firewalls
AMG1302-T10A User’s Guide
147
10.3.2 Customized Services
Configure customized services and port numbers not predefined by the Device. For a
comprehensive list of port numbers and services, visit the IANA (Internet Assigned Number
Authority) website. Click the Edit Customized Services link while editing a firewall rule to
configure a custom service port. This displays the following screen.
Figure 80 Security > Firewall > Rules: Edit: Edit Customized Services
Start IP Address Enter the single IP address or the starting IP address in a range here.
End IP Address Enter the ending IP address in a range here.
Subnet Mask Enter the subnet mask here, if applicable.
Add >> Click Add >> to add a new address to the Source or Destination Address box. You
can add multiple addresses, ranges of addresses, and/or subnets.
Edit << To edit an existing source or destination address, select it from the box and click Edit
<<.
Delete Highlight an existing source or destination address from the Source or Destination
Address box above and click Delete to remove it.
Service
Available / Selected
Services
Highlight a service from the Available Services box on the left, then click Add >> to
add it to the Selected Services box on the right. To remove a service, highlight it in
the Selected Services box on the right, then click Remove.
Edit Customized
Service
Click the Edit Customized Services link to bring up the screen that you use to
configure a new custom service that is not in the predefined list of services.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 53 Security > Firewall > Rules: Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
