Chapter 7 LAN Setup
AMG1302-T10A User’s Guide
92
7.6 The IPv6 Screen
Use this screen to configure the IPv6 settings for your Device’s LAN interface. See Appendix E on
page 281 for background information about IPv6.
Figure 44 Network > LAN > IPv6
The following table describes the labels in this screen.
Table 27 Network > LAN > IPv6
LABEL DESCRIPTION
Radvd Setup
Radvd Enable Select Enable to have the Device send router advertisement messages to the LAN
hosts.
Router advertisement is a response to a router solicitation or a periodical multicast
advertisement from a router to advertise its presence and other parameters, such as
IPv6 prefix and DNS information.
Router solicitation is a request from a host to locate a router that can act as the
default router and forward packets.
Note: The LAN hosts neither generate global IPv6 addresses nor communicate with
other networks if you disable this feature.
Radvd Mode If Auto is selected, the Device will pass IPv6 prefix and DNS information in router
advertisements.
If Mannual is selected, you can specify the IPv6 network prefix information for router
advertisement.
Prefix / Length If manual router advertisement mode is selected, specify the IPv6 prefix and prefix
length to pass to hosts.
Preferred Lifetime Enter the preferred lifetime for the prefix.
Valid Lifetime Enter the valid lifetime for the prefix.
To Next Page
Loading...
