Chapter 7 LAN Setup
AMG1302-T10A User’s Guide
90
Use this screen to change your Device’s static DHCP settings. Click Network > LAN > Client List
to open the following screen.
Figure 41 Network > LAN > Client List
The following table describes the labels in this screen.
7.5 The IP Alias Screen
IP alias allows you to partition a physical network into different logical networks over the same
Ethernet interface. The Device supports logical LAN interfaces via its single physical Ethernet
interface with the Device itself as the gateway for each LAN network.
Table 25 Network > LAN > Client List
LABEL DESCRIPTION
IP Address Enter the IP address that you want to assign to the computer on your LAN with the MAC
address that you will also specify.
MAC Address Enter the MAC address of a computer on your LAN.
Add Click this to add a static DHCP entry.
# This is the index number of the static IP table entry (row).
Status This field displays whether the client is connected to the Device.
Host Name This field displays the computer host name.
IP Address This field displays the IP address relative to the # field listed above.
MAC Address The MAC (Media Access Control) or Ethernet address on a LAN (Local Area Network) is
unique to your computer (six pairs of hexadecimal notation).
A network interface card such as an Ethernet adapter has a hardwired address that is
assigned at the factory. This address follows an industry standard that ensures no other
adapter has a similar address.
Reserve Select the check box in the heading row to automatically select all check boxes or
select the check box(es) in each entry to have the Device always assign the selected
entry(ies)’s IP address(es) to the corresponding MAC address(es) (and host name(s)).
You can select up to 10 entries in this table.
Modify Click the modify icon to have the IP address field editable and change it.
Apply Click this to save your changes.
To Next Page
Loading...
