Chapter 7 LAN Setup
AMG1302-T10A User’s Guide
87
1 Enter an IP address into the IP Address field. The IP address must be in dotted decimal notation.
This will become the IP address of your Device.
2 Enter the IP subnet mask into the IP Subnet Mask field. Unless instructed otherwise it is best to
leave this alone, the configurator will automatically compute a subnet mask based upon the IP
address you entered.
3 Click Apply to save your settings.
Figure 38 Network > LAN > IP
The following table describes the fields in this screen.
7.2.1 The Advanced LAN IP Setup Screen
Use this screen to edit your Device's RIP, multicast and Windows Networking settings. Click the
Advanced Setup button in the LAN IP screen. The screen appears as shown.
Figure 39 Network > LAN > IP: Advanced Setup
Table 22 Network > LAN > IP
LABEL DESCRIPTION
IP Address Enter the LAN IP address you want to assign to your Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Device automatically computes the subnet mask
based on the IP Address you enter, so do not change this field unless you are
instructed to do so.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Advanced Setup Click this to display the Advanced LAN Setup screen and edit more details of your
LAN setup.
To Next Page
Loading...
