Chapter 6 WAN Setup
AMG1302-T10A User’s Guide
74
6.2.1 Advanced Internet Access Setup
Use this screen to edit your Device's advanced WAN settings. Click the Advanced Setup button in
the Internet Access Setup screen. The screen appears as shown.
Figure 33 Network > WAN > Internet Access Setup: Advanced Setup
The following table describes the labels in this screen.
Table 18 Network > WAN > Internet Access Setup: Advanced Setup
LABEL DESCRIPTION
RIP & Multicast Setup
RIP Direction RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. Use this field to control how much routing information the Device
sends and receives on the subnet.
Select the RIP direction from None, Both, In Only and Out Only.
RIP Version This field is not configurable if you select None in the RIP Direction field.
Select the RIP version from RIP-1, RIP-2B/RIP-2M. Select RIP-1 to use RIP version
1. Select RIP-2B/RIP-2M to use RIP version 2 broadcast and multicast.
Multicast Multicast packets are sent to a group of computers on the LAN and are an alternative
to unicast packets (packets sent to one computer) and broadcast packets (packets
sent to every computer).
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish
membership in a multicast group. The Device supports IGMP-v1 and IGMP-v2.
Select None to disable it.
ATM Q oS
To Next Page
Loading...
