ZyXEL Communications AMG1302-T10A - Page 73

Chapter 6 WAN Setup
AMG1302-T10A User’s Guide
73
IPv6 Message Fetch
Type
If the encapsulation type is ENET ENCAP, you can select Dynamic Mode to
automatically obtain an IP address or Static Mode to enter a static IP address.
DHCP IPv6 Enable Select DHCP if you want to obtain an IPv6 address from a DHCPv6 server.
The IP address assigned by a DHCPv6 server has priority over the IP address
automatically generated by the Device using the IPv6 prefix from an RA.
Select SLAAC (Stateless address autoconfiguration) to have the Device use the prefix
to automatically generate a unique IP address that does not need to be maintained by
a DHCP server.
DHCP PD Enable Select Enable to use DHCP PD (Prefix Delegation) to allow the Device to pass the
IPv6 prefix information to its LAN hosts. The hosts can then use the prefix to generate
their IPv6 addresses.
IPv6 Address Enter the IPv6 address assigned by your ISP.
IPv6 Default Gateway Enter the gateway IPv6 address provided by your ISP.
IPv6 DNS Server1 Enter the first IPv6 DNS server address assigned by the ISP.
IPv6 DNS Server2 Enter the second IPv6 DNS server address assigned by the ISP.
MLD Proxy Select Enable to have the Device act as an MLD proxy on this connection. This allows
the Device to get subscription information and maintain a joined member list for each
multicast group. It can reduce multicast traffic significantly.
Connection (PPPoA and PPPoE encapsulation only)
Keep Alive Select Keep Alive when you want your connection up all the time. The Device will try
to bring up the connection automatically if it is disconnected.
Connect Manually Select Connect Manually when you don't want the connection up all the time, and
would prefer to connect manually. You can activate the connection by clicking the
Connect button on the Status screen.
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.
Advanced Setup Click this to display the Advanced WAN Setup screen and edit more details of your
WAN setup.
Table 17 Network > WAN > Internet Access Setup (continued)
LABEL DESCRIPTION