Chapter 11 Filters
AMG1302-T10A User’s Guide
157
Subnet Mask Enter the IP subnet mask for the destination IP address.
Port Number Enter the destination port of the packets that you wish to filter. The range of
this field is 0 to 65535. This field is ignored if it is 0.
Protocol Select ICMP, TCP or UDP for the upper layer protocol.
MAC Address This field is only available when you select MAC in the Rule Type field.
Enter the MAC address of the packets you wish to filter.
IP/MAC Filter Listing
IP/MAC Filter Set Index Select the index number of the filter set from the drop-down list box.
Interface This is the interface that the filter set applies to.
Direction The filter set applies to this traffic direction.
# This is the index number of the rule in a filter set.
Active This field shows whether the rule is activated.
Src IP/Mask This is the source IP address and subnet mask when you select IP as the rule
type.
Dest IP/Mask This is the destination IP address and subnet mask.
Mac Address This is the MAC address when you select MAC as the rule type.
Src Port This is the source port number.
Dest Port This is the destination port number.
Protocol This is the upper layer protocol.
Save Click this to save your changes.
Delete Click this to remove the filter rule.
Cancel Click this to restore your previously saved settings.
Table 58 Access Management > Filter (IP/MAC) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
