ZyXEL Communications AMG1302-T10A - Page 29

Chapter 3 Status Screens
AMG1302-T10A User’s Guide
29
IPv4 WAN Information
DSL Mode This is the DSL standard that your Device is using.
Annex Type
IP Address This is the current IP address of the Device in the WAN. Click this to go to the screen
where you can change it.If Connect Manually is enabled in Internet Access Setup,
you can click Connect to connect to the WAN.
IP Subnet Mask This is the current subnet mask in the WAN.
Default
Gateway
This is the IP address of the default gateway, if applicable.
VPI/VCI This is the Virtual Path Identifier and Virtual Channel Identifier that you entered in the
wizard or WAN screen.
IPv6 WAN Information
DSL Mode This is the DSL standard that your Device is using.
IPv6 Address This is the current IPv6 address of the Device in the WAN. Click this to go to the screen
where you can change it.
Default
Gateway
This is the IPv6 address of the default gateway, if applicable.
VPI/VCI This is the Virtual Path Identifier and Virtual Channel Identifier that you entered in the
wizard or WAN screen.
IPv4 LAN Information
IP Address This is the current IP address of the Device in the LAN. Click this to go to the screen
where you can change it.
IP Subnet Mask This is the current subnet mask in the LAN.
DHCP This field displays what DHCP services the Device is providing to the LAN. Choices are:
Server - The Device is a DHCP server in the LAN. It assigns IP addresses to other
computers in the LAN.
Relay - The Device acts as a surrogate DHCP server and relays DHCP requests and
responses between the remote server and the clients.
None - The Device is not providing any DHCP services to the LAN.
Click this to go to the screen where you can change it.
IPv6 LAN
Information
IPv6 Address This is the current IPv6 address of the Device in the LAN. Click this to go to the screen
where you can change it.
WLAN Information
ESSID This is the descriptive name used to identify the Device in a wireless LAN. Click this to
go to the screen where you can change it.
Channel This is the channel number used by the Device now.
Security This displays the type of security mode the Device is using in the wireless LAN.
WPS This displays whether WPS is activated. Click this to go to the screen where you can
configure the settings.
Status This displays whether WLAN is activated.
Security
Firewall This displays whether or not the Device’s firewall is activated. Click this to go to the
screen where you can change it.
System Status
Table 4 Status Screen
LABEL DESCRIPTION