Chapter 33 IPv6 Commands
Ethernet Switch CLI Reference Guide
147
ipv6 address <ipv6-address>/
<prefix> link-local
Manually configures a static IPv6 link-local address for the
VLAN.
C13
ipv6 address autoconfig Use the command to have the Switch generate an IPv6
global address automatically in this VLAN after the Switch
obtains the VLAN network information from a router.
Note: Make sure an IPv6 router is available in
the VLAN network before using this
command on the Switch.
C13
ipv6 address default-gateway
<gateway-ipv6-address>
Sets the default gateway for the VLAN. When an interface
cannot find a routing information for a frame’s destination,
it forwards the packet to the default gateway.
C13
ipv6 address dhcp client <ia-
na>
Sets the Switch to get a non-temporary IP address from
the DHCP server.
C13
ipv6 address dhcp client <ia-
na> [rapid-commit]
Sets the Switch to get a non-temporary IP address from
the DHCP server for this VLAN. Optionally, sets the
Switch to send its DHCPv6 Solicit message with a Rapid
Commit option to obtain information from the DHCP
server by a rapid two-message exchange. The Switch
discards any Reply messages that do not include a Rapid
Commit option. The DHCPv6 server should also support
the Rapid Commit option to have it work well.
C13
ipv6 address dhcp client
information refresh minimum
<600-4294967295>
Sets the time interval (in seconds) at which the Switch
exchanges other configuration information with a DHCPv6
server again.
C13
ipv6 address dhcp client
option <[dns][domain-list]>
Sets the Switch to obtain DNS server IPv6 addresses or a
list of domain names from the DHCP server.
C13
no ipv6 Disables IPv6 in this VLAN. C 13
no ipv6 address <ipv6-
address>/<prefix>
Removes a specified static global address. C 13
no ipv6 address <ipv6-
address>/<prefix> eui-64
Removes a specified static global address whose
interface ID was generated using the EUI-64 format.
C13
no ipv6 address <ipv6-
address>/<prefix> link-local
Removes a specified static link-local address. C 13
no ipv6 address autoconfig Disables IPv6 address autoconfiguration in this VLAN. C 13
no ipv6 address default-
gateway
Removes the default gateway address for this VLAN. C 13
no ipv6 address dhcp client Disables the DHCP client feature in this VLAN. C 13
no ipv6 address dhcp client
[rapid-commit]
sets the Switch to not include a Rapid Commit option in its
DHCPv6 Solicit messag for this VLAN.
C13
no ipv6 address dhcp client
option
Sets the Switch to not obtain the DNS server information
from the DHCP server.
C13
no ipv6 address dhcp client
option <[dns][domain-list]>
Sets the Switch to not obtain DNS server IPv6 addresses
or a list of domain names from the DHCP server.
C13
restart ipv6 dhcp client vlan <1-
4094>
Sets the Switch to send a Release message for the
assigned IPv6 address to the DHCP server and start
DHCP message exchange again.
E13
show ipv6 Displays IPv6 settings in all VLANs on the Switch. E 3
Table 87 ipv6 address Command Summary (continued)
COMMAND DESCRIPTION M P
To Next Page
Loading...
Need help?
General
