ZyXEL Communications GS1900-8 - The Loop Guard Port; The Port Edit Screen

Chapter 23 Configuration: Loop Guard
GS1900 Series User’s Guide
138
23.2.2 The Loop Guard Port
Use this screen to view the Loop Guard Port. Click Configuration > Loop Guard > Port to open
this screen.
Figure 131 Configuration > Loop Guard > Port
The following table describes the labels in this screen.
23.2.3 The Port Edit Screen
Use this screen to configure a Loop Guard port. Click Configuration > Loop Guard > Port > Edit
to open this screen.
Recovery Time Enter the period (in seconds) for which a port will be kept disabled in the event of a loop is
detected (and the port action shuts down the port).
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.
Table 96 Configuration > Loop Guard (continued)
LABEL DESCRIPTION
Table 97 Configuration > Loop Guard > Port
LABEL DESCRIPTION
Port
Edit Click Edit to change the properties of the port.
Port Displays the port index number.
State Displays whether the port state is Enable or Disable.
Action Displays the action to take by the Switch. The options are Log, Shutdown Port, and
Shutdown and Log.