ZyXEL Communications GS1900-8 - The Port Rate Edit Screen

Chapter 19 Configuration: Port
GS1900 Series User’s Guide
110
19.5.2 The Port Rate Edit Screen
Use this screen to configure port rate Bandwidth Management settings. Click Configuration >
Port > Bandwidth Management > Bandwidth Control > Edit to open this screen.
Figure 101 Configuration > Port > Bandwidth Management > Bandwidth Control > Edit
The following table describes the labels in this screen.
Ingress Rate
Limit (Kbps)
Displays the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port.
Egress Rate
Limit (Kbps)
Displays the maximum bandwidth allowed in kilobits per second (Kbps) for the outgoing
traffic flow on a port.
Table 67 Configuration > Port > Bandwidth Management > Bandwidth Control (continued)
LABEL DESCRIPTION
Table 68 Configuration > Port > Bandwidth Management > Bandwidth Control > Edit
LABEL DESCRIPTION
Port Rate
Port List Displays the list of port index numbers that are being configured.
Ingress State Select Enable to activate ingress peak rate limits on the port(s).
Ingress
Bandwidth
(Kbps)
Enter the maximum bandwidth allowed in kilobits per second (Kbps) for the outgoing traffic
flow on a port.
Egress State Select Enable to activate egress peak rate limits on the port(s).
Egress
Bandwidth
(Kbps)
Enter the maximum bandwidth allowed in kilobits per second (Kbps) for the outgoing traffic
flow on a port.
Apply Click Apply to save the changes.
Cancel Click Cancel to discard the changes.