Chapter 31 Configuration: Management
GS1900 Series User’s Guide
212
31.7.2 The Profile Add/Modify Screen
Use this screen to configure the Profile settings. Click Configuration > Management > Remote
Access Control > Profile > Add/Modify to open this screen.
Figure 209 Configuration > Management > Remote Access Control > Profile > Add/Modify
The following table describes the labels in this screen.
Source IP Display the source IP value.
Source IP Mask Displays the source IP wildcard.
Port Display the port value.
Service Display the service used for remote access. The values are ALL, HTTP, HTTPS, or SNMP.
Action
Edit Click Edit to make changes to the entry.
Delete Click Delete to remove the entry.
Table 174 Configuration > Management > Remote Access Control (continued)
LABEL DESCRIPTION
Table 175 Configuration > Management > Remote Access Control > Profile > Add/Modify
LABEL DESCRIPTION
Management Access List Add
No. Enter the priority level of the entry. The value can be between 1 and 16.
Action Select the action value. The values are Permit or Deny.
To Next Page
Loading...
