Chapter 9 Maintenance
HES-309M Series User’s Guide
120
9.4 Telnet
Use this screen to allow remote access to the WiMAX Device from a network
connection over Telnet.
Click Maintenance > Remote MGMT > Telnet to open this screen as shown
next.
Figure 53 Telnet Screen
This screen contains the following fields:
Allow
Connection
from WAN
Select this to allow incoming connections from the WAN over either
HTTP or HTTPS.
HTTP Session Timeout
Session
Timeout
Enter the number of minutes (0-99) the WiMAX Device waits to delete
an inactive web connection (HTTP or HTTPS).
Table 42 HTTP (continued)
LABEL DESCRIPTION
Table 43 Telnet
LABEL DESCRIPTION
Enable Select this to enable remote management using this service.
Port Number Enter the port number this service can use to access the WiMAX Device.
The computer must use the same port number.
Allow
Connection
from WAN
Select this to allow connections using this service that originate on the
WAN.
Allow
Connection
from LAN
Select this to allow connection using this service that originate on the
LAN.
To Next Page
Loading...
