Chapter 7 Network Settings
HES-309M Series User’s Guide
93
5 Only Jane can connect to the Real Audio server until the connection is closed or
times out. The WiMAX Device times out in three minutes with UDP (User
Datagram Protocol), or two hours with TCP/IP (Transfer Control Protocol/Internet
Protocol).
Two points to remember about trigger ports:
1 Trigger events only happen on data that is coming from inside the WiMAX Device
and going to the outside.
2 If an application needs a continuous data stream, that port (range) will be tied up
so that another computer on the LAN can’t trigger it.
7.12 DMZ
Use this page to set the IP address of your network DMZ (if you have one) for the
WiMAX Device. All incoming packets received by this WiMAX Device’s WAN
interface will be forwarded to the DMZ host you set.
Click Network Setting > NAT > DMZ to open this screen as shown next.
Note: The configuration you set in this screen takes priority than the Network Setting
> NAT > Port Forwarding screen.
Figure 39 DMZ Screen
This screen contains the following fields:
Table 32 DMZ
LABEL DESCRIPTION
DMZ Host Enter the IP address of your network DMZ host, if you have one.
0.0.0.0 means this feature is disabled.
To Next Page
Loading...
