Chapter 9 Maintenance
HES-309M Series User’s Guide
121
9.5 SSH
Use this screen to allow remote access to the WiMAX Device from a network
connection over SSH.
Click Maintenance > Remote MGMT > SSH to open this screen as shown next.
Figure 54 SSH Screen
This screen contains the following fields:
Table 44 SSH
LABEL DESCRIPTION
Enable Select this to enable remote management using this service.
Port Number Enter the port number this service can use to access the WiMAX Device.
The computer must use the same port number.
Allow
Connection
from WAN
Select this to allow connections using this service that originate on the
WAN.
Allow
Connection
from LAN
Select this to allow connection using this service that originate on the
LAN.
To Next Page
Loading...
