Chapter 9 Maintenance
HES-309M Series User’s Guide
127
9.9 Date
Use these settings to set the system time or configure an NTP server for automatic
time synchronization.
Click Maintenance > Date/Time > Date to open this screen as shown next.
Figure 58 Date Screen
This screen contains the following fields:
Table 48 Date
LABEL DESCRIPTION
Manual
New Time
Enter the new time in this field.
New Date Enter the new date in this field.
Get from Time Server
Time
Protocol
Select the time service protocol that your time server uses.Check with
your ISP or network administrator, or use trial-and-error to find a
protocol that works.
• NTP (RFC 1305) - This format is similar to Time (RFC 868).
Time Server
Address 1~4
Enter the IP address or URL of your time server. Check with your ISP or
network administrator if you are unsure of this information.
To Next Page
Loading...
